Areas of Plane Figures
Every odd shape is a few standard shapes added and subtracted.
Before this Lesson
A stop sign has no length and width to multiply, yet it's only eight identical triangles sharing a center. The water in a partly full pipe looks worse, with a flat top and a curved bottom, but it's a slice of pie with a triangle taken off. Exam figures come apart the same way. Find the cuts, and the only areas left to compute are ones you already know.
Most shapes are rearranged rectangles
A rectangle's area is width times height. Several other standard shapes are that same rectangle after some cutting and sliding.
Slide the triangle off one end of a parallelogram to the other, and you have a rectangle with the same area: . The height is the perpendicular one, not the slanted side. If you know the slanted side and the angle between the sides, then , so .
Cut a parallelogram along its diagonal, and you have two identical triangles, so each gets half the base times the height, with now the base: . Set a trapezoid beside an upside-down copy of itself, and the pair makes a parallelogram with base . One trapezoid then has , the average of the parallel sides times the height.
Problems often skip the height. In Triangle Trigonometry, turned half base times height into , with between and . The Handbook doesn't print this form, so keep it in your head.
Two curved shapes round out the set. An ellipse is a circle that got stretched. A circle of radius has area . Stretch it one way until its half-height is , and one of those s becomes : . Both are semi-axes, measured from the center, so they're half the full width and half the full height.
A parabolic segment is what you get by cutting straight across a parabola, such as the opening under a parabolic arch. It fills exactly two-thirds of the box around it: , with the width and the height. Proving that takes an integral, the tool of Integrals and Area, though Archimedes managed it without one nearly two thousand years before calculus.
The Handbook splits these up. Mensuration of Areas and Volumes prints the parallelogram, ellipse, and parabola. The rectangle, triangle, trapezoid, and circle sit in the Statics table under Centroids and Moments of Inertia. Watch the parabola's letters. Mensuration draws half a segment, with for that half and for the corner left over in its box. Statics gives the whole segment as , with as the height and as the half-width. Both say two-thirds of the box.
Composite figures: a list of pluses and minuses
This is the habit the whole Lesson rests on. A composite figure is a list of standard shapes, each with a plus or a minus, so write the list before you compute anything. Whatever sticks out is a plus, and a hole or a bite is a minus. Half a circle gets half the formula.
Radians: an angle measured with the radius
Now for circles. Degrees are a convention: 360 is handy because so many numbers divide it, but nothing about a circle says 360. A circle has its own way to measure an angle, which is to divide the arc by the radius:
Bend one radius along the rim, and the angle it covers is 1 radian, about 57.3°. The whole rim is long, so a full turn is radians. That gives the conversion: multiply degrees by .
Mensuration prints under Circular Sector but never states a unit, and the Handbook never defines a radian. Its Units and Conversion Factors table lists only the other direction: radians times gives degrees.
That definition is why the arc formula needs radians. Rearranged, it says , and has to be that same ratio. Take a 10 ft radius and a 60° angle. With , the arc is 10.5 ft. With 60 left in, you'd get 600 ft of arc on a circle whose whole rim is 63 ft.
Sector, chord, and segment
A sector is a slice of pie. Its angle is the fraction of a full turn, so it gets that fraction of the circle's area:
Circular Sector prints both of those last forms. The second looks like half base times height, with the arc as the base and the radius as the height, and that's just what a thin slice is.
A chord is the straight line between the arc's two ends. Mensuration draws one with no formula, and the Handbook's closest print is under Horizontal Curves, where uses for the angle. It's easy to build. A line from the center to the chord's middle makes two right triangles, each with hypotenuse and a half-angle of . Half the chord sits opposite that angle:
A segment is the sliver between the chord and the arc, like the water in that pipe. It isn't a new shape: it's the sector minus the triangle. That triangle has two sides of with between them, so its area is :
The last form is under Circular Segment, next to , which finds the angle when a problem gives you the segment's height instead.
Inside a sine or tangent, the angle only has to match the calculator's angle mode. Outside one, it has to be radians. For 60°, stay in degree mode and enter , or switch to radian mode and enter . Both give 0.181. Radian mode with gives 1.352, and nothing warns you.
Regular polygons: n identical triangles
Back to the stop sign. A regular polygon has equal sides and equal angles. Draw a line from the center to each corner, and it falls into identical isosceles triangles. They share the full turn equally, so each has a central angle of:
Each triangle's base is a side of the polygon, which the Handbook calls , the same letter it used for the arc. The height runs from the center straight to the middle of that side, and the Handbook calls it : the radius of the inscribed circle, the largest circle that fits inside. Geometry books call it the apothem. One triangle's area is , so all give:
That height also cuts each triangle into two right triangles, with at the center, opposite it, and adjacent. So , or:
All three are under Regular Polygon in Mensuration, and exam questions run through them in either direction. Given the side, solve that last equation for . Given , use it as written to find . Either way, finish with .
Compare the chord, . It's the same triangle, but the chord's is the slanted side, so it takes a sine, while a polygon's is the height, so it takes a tangent. The line from the center to a corner is longer than . If a problem gives you that distance instead, call it : each triangle then has two sides of with between them, and an area of .
The central angle isn't the one you'd measure at a corner. For that one, imagine walking around the edge. You turn by the same amount at each corner, and after corners you've made one full turn, so each turn is , which is . The interior angle is what that turn leaves of a straight line:
That's the Handbook's formula, which it also writes as . In degrees, it's , so an octagon has and . The perimeter is simplest of all, , so a perimeter hands you the side as well.
How area scales
Cover any figure with tiny square tiles. Now stretch the figure to times its width and leave the height alone. Every tile gets times wider, so the area is times bigger. Stretch the height by as well, and every tile grows both ways, so the area is times bigger. Curved edges make no difference.
The Handbook says nothing about this, and it doesn't need to. Every area formula multiplies two lengths, so the only question is which lengths actually changed.