Vertical Curve Geometry

A vertical curve changes grade at a steady rate, and that makes it a parabola.

Before this Lesson

A designer's first sketch of a hill is two straight lines: a climb at +3% and a descent at −1%, meeting in a sharp corner. At highway speed, that corner would kick the car hard, so it gets rounded off. By the end of this Lesson, you'll start from the corner's station and elevation and say how high the road is at any station along the curve that replaces it.

Two grades and the corner between them

Look at the road from the side, with the height stretched so the grades show. That's a profile. The straight stretch you arrive on is the back tangent, with grade g1g_1. The one you leave on is the forward tangent, with grade g2g_2. Extended, they meet at the PVI, the point of vertical intersection, which is the corner from the sketch. The curve leaves the back tangent at the PVC, the point of vertical curvature, and joins the forward tangent at the PVT, the point of vertical tangency.

PVC PVI PVT Back tangent, g1 Forward tangent, g2 L/2 L/2 L
The parts of a vertical curve

Adapted from the FE Reference Handbook, Vertical Curve Formulas

The curve's length LL is measured horizontally, along the stations, and the PVC and PVT each sit exactly L/2L/2 from the PVI. That makes this an equal-tangent curve, the kind the Handbook's formulas assume, though its Vertical Curves section never uses the name or prints these station relations. Choosing LL is the job of Vertical Curve Length for Sight Distance. Here, it's given.

The elevations come from walking along the tangents, because the curve's two ends lie on them:

PVC station=PVI station−L2YPVC=YPVI−g1L2PVT station=PVI station+L2YPVT=YPVI+g2L2\begin{aligned} \text{PVC station} &= \text{PVI station} - \tfrac{L}{2} & Y_{\text{PVC}} &= Y_{\text{PVI}} - g_1\tfrac{L}{2} \\ \text{PVT station} &= \text{PVI station} + \tfrac{L}{2} & Y_{\text{PVT}} &= Y_{\text{PVI}} + g_2\tfrac{L}{2} \end{aligned}

Here g1g_1 and g2g_2 are decimals, the percent grade divided by 100, just as the Handbook defines them. Give our hill an 800-ft curve, with the PVI at station 20+00, elevation 500.00 ft. Half of 800 is 400, so the PVC is at 16+00 and the PVT is at 24+00. Walk back down the +3% tangent, and YPVC=500.00−(0.03)(400)=488.00 ftY_{\text{PVC}} = 500.00 - (0.03)(400) = 488.00\ \text{ft}. Walk ahead down the −1% tangent, and YPVT=500.00+(−0.01)(400)=496.00 ftY_{\text{PVT}} = 500.00 + (-0.01)(400) = 496.00\ \text{ft}. The PVI itself isn't on the road. It's a point in the air above it.

This hill is a crest: the grade falls as you go, so g2−g1g_2 - g_1 is negative. A sag is the reverse: the grade rises, and g2−g1g_2 - g_1 is positive. That difference decides it, whatever the signs of the grades themselves, so +4% easing to +1% is a crest even though the road never stops climbing. The size of the change is the algebraic difference in grades, which the Handbook defines as A=∣g2−g1∣×100A = |g_2 - g_1| \times 100, in percent. Our hill has A=4A = 4, because going from +3% to −1% changes the grade by 4, not 2.

Checkpoint
1 of 2

A sag curve 600 ft long joins a −2.5% grade to a +1.5% grade. Its PVI is at station 32+50, elevation 612.40 ft. Where is the PVC?

A.
Station 29+50, elevation 619.90 ft
B.
Station 29+50, elevation 604.90 ft
C.
Station 26+50, elevation 627.40 ft
D.
Station 35+50, elevation 604.90 ft

A steady change of grade makes a parabola

Here's the idea behind the curve's shape: the grade changes at a steady rate from one end to the other. A car at constant speed then feels one smooth, unchanging push through the whole curve, with no jolt. The Handbook calls that rate rr, the rate of change of grade:

r=g2−g1Lr = \frac{g_2 - g_1}{L}

Our hill has 4% of grade to lose over 8 stations, so it loses 0.5% per station: +3% at the PVC, +2.5% a station later, +2% after that, on down to −1% at the PVT. In the Handbook's units, that's r=−0.04/800=−0.00005r = -0.04/800 = -0.00005 per foot.

Now find the elevation. Go xx feet past the PVC, measured horizontally, as xx always is here. The grade has gone steadily from g1g_1 to g1+rxg_1 + rx, so the average grade over that stretch is halfway between them. The rise is that average grade times the run:

Y=YPVC+(g1+rx2)x=YPVC+g1x+r2x2Y = Y_{\text{PVC}} + \left(g_1 + \frac{rx}{2}\right)x = Y_{\text{PVC}} + g_1x + \frac{r}{2}x^2

There's the square. A grade that changes steadily gives an elevation that's quadratic in distance, which is a parabola. Half of rr gets its own name, aa, the parabola constant, and the Handbook's Vertical Curves section prints the result:

Curve elevation=YPVC+g1x+ax2a=g2−g12L\text{Curve elevation} = Y_{\text{PVC}} + g_1x + ax^2 \qquad a = \frac{g_2 - g_1}{2L}
PVC PVI PVT −2 −1 0 +1 +2 +3 +4 Grade (%) +3% −1% straight line 484 488 492 496 500 504 0 200 400 600 800 x, distance from the PVC (ft) Elevation (ft) parabola
A straight line in grade is a parabola in elevation
Our hill, drawn twice over the same distance.

The top of the hill is where the grade passes through zero, and finding it belongs to High and Low Points on Vertical Curves.

Read the equation in two pieces. YPVC+g1xY_{\text{PVC}} + g_1x is the back tangent, the straight line the road would follow if it never bent. ax2ax^2 is the tangent offset, yy in the Handbook: how far the curve has peeled away from that line, measured vertically. The sign lives in aa. It's negative on a crest, so the curve drops below the tangent, and positive on a sag, so the curve rises above it.

The Handbook prints the forward tangent too, YPVI+g2(x−L/2)Y_{\text{PVI}} + g_2(x - L/2), joined to the back tangent's expression by an equals sign. They're two lines that agree only at the PVI, so read that sign as "or."

Keep the units matched

Decimal grades go with feet, which is the Handbook's way. Percent grades with xx and LL in stations also work, because the hundreds cancel. Mix the two, and the offset comes out 100 times off.

Worked Example The elevation of a sag curve at a station
1 of 3

A sag curve 600 ft long joins a −2% grade to a +4% grade. Its PVI is at station 52+40, elevation 310.00 ft. Find the elevation of the curve at station 51+40.

PVC PVT PVI Sta. 52+40 Elev. 310.00 Sta. 51+40 Elev. = ? g1 = −2% g2 = +4% L = 600 ft
The sag curve and the station in question

The offset grows with the square

All of the curve's bend lives in ax2ax^2. Our hill has a=−0.04/1,600=−0.000025a = -0.04/1{,}600 = -0.000025, so 200 ft past the PVC, the offset is (−0.000025)(200)2=−1 ft(-0.000025)(200)^2 = -1\ \text{ft}. Keep walking in equal 200-ft steps and the gap goes 1 ft, 4 ft, 9 ft, 16 ft. Double the distance from the PVC, and the offset quadruples.

484 492 500 508 516 0 200 400 600 800 x, distance from the PVC (ft) Elevation (ft) 1 ft 4 ft 9 ft 16 ft PVC PVI PVT Curve Back tangent, extended
Equal steps along our hill give offsets of 1, 4, 9, and 16 ft

Even past the PVI, where the forward tangent is the nearer line, y=ax2y = ax^2 measures to the back tangent, extended, and xx still runs from the PVC. A problem that asks for the offset from the forward tangent runs the same law backward from the PVT, as a(L−x)2a(L - x)^2.

Two stops on that walk matter most. At the PVT, x=Lx = L and the offset is aL2aL^2. At the PVI, x=L/2x = L/2, and the square makes the offset a quarter of that. The Handbook calls this one E=a(L/2)2E = a(L/2)^2, the tangent offset at the PVI, and you'll also hear it called the middle offset. Because the PVI sits on the back tangent, it's also the distance from the PVI to the curve. Put in aa, and it collapses:

∣E∣=∣g2−g1∣2L(L2)2=∣g2−g1∣ L8=AL800|E| = \frac{|g_2 - g_1|}{2L}\left(\frac{L}{2}\right)^2 = \frac{|g_2 - g_1|\,L}{8} = \frac{AL}{800}

The 8 is the 2 in aa times the 4 from squaring L/2L/2, and the extra 100 is there because AA is in percent. LL stays in feet. The Handbook prints only E=a(L/2)2E = a(L/2)^2, so AL/800AL/800 is one you carry in your head. It gives the size alone, so take the direction from the picture: the curve passes below the PVI on a crest and above it on a sag. For our hill, (4)(800)/800=4 ft(4)(800)/800 = 4\ \text{ft}, just as the walk said.

Checkpoint
1 of 3

A sag curve 500 ft long joins a −3% grade to a +2% grade, and its PVC is at station 30+00. How far above the back tangent is the curve at station 33+00?

ft

Halfway to the long chord

Three properties of this curve show up as exam questions of their own. You've met two of them. The rate of change of grade is constant from end to end, and with LL in its denominator, it falls as the curve lengthens: the same change in grade, spread over more road. And the PVI lies horizontally midway between the PVC and PVT, whatever the grades are.

The third is the neat one. Draw the long chord, the straight line from the PVC to the PVT. Its midpoint falls at the PVI's station, and the curve passes exactly halfway between that midpoint and the PVI.

4 ft 4 ft PVC 488.00 PVT 496.00 PVI 500.00 Curve 496.00 Chord midpoint 492.00 Long chord L/2 = 400 ft L/2 = 400 ft
At the PVI's station, the curve is halfway to the long chord

The square law says why. Measure every gap from the back tangent. At the PVT, the chord and the curve meet, 16 ft down on our hill. The chord is straight, so its gap grows in proportion to distance, and halfway along, it's half of 16, or 8 ft. The curve's gap grows with the square, so halfway along, it's a quarter of 16, or 4 ft. A quarter is half of a half, on any curve, so the curve always lands halfway between the PVI and the chord.

The chord's midpoint elevation is just the average of the PVC and PVT elevations, so this gives you the curve at the PVI's station with no grades at all. The Handbook's Vertical Curves section doesn't draw the long chord or state this property, so it's another one you carry in your head.

Checkpoint
1 of 3

Which statements are true of an equal-tangent vertical curve?

A.
The grade changes at a constant rate along the curve
B.
For the same two grades, a longer curve has a larger rate of change of grade
C.
The PVI lies horizontally midway between the PVC and PVT
D.
The curve passes through the midpoint of the long chord
E.
At the PVI's station, the curve is halfway between the PVI and the long chord's midpoint

Recap

  • The PVC and PVT sit L/2L/2 horizontally either side of the PVI, and their elevations come from walking along the tangents.
  • The grade changes steadily, so the elevation is a parabola: YPVC+g1x+ax2Y_{\text{PVC}} + g_1x + ax^2, with a=(g2−g1)/2La = (g_2 - g_1)/2L and xx in feet from the PVC.
  • The curve is the back tangent plus the offset ax2ax^2, negative on a crest and positive on a sag.
  • The middle offset at the PVI is a quarter of the offset at the PVT, and its size is AL/800AL/800, with AA in percent and LL in feet.
  • A longer curve has a smaller rate of change of grade, and the curve passes halfway between the PVI and the long chord's midpoint.