Back

Water Resources and Environmental Engineering

  • Topic 10
  • 20 Lessons

Overview

This is the broadest topic on the exam. It runs from a storm on a hillside to the river below a treatment plant, by way of ditches, sewers, water mains, pumps, wells, and settling tanks. It looks like a dozen subjects, but nearly every question in it makes the same move: draw a boundary around one piece of the system, and keep the books on what crosses it. Whatever comes in must go out, be stored, or react.

in=out+stored+reacted\text{in} = \text{out} + \text{stored} + \text{reacted}

So write the balance first. After that, only two decisions are left: whether you're balancing the water itself or the mass it carries, and which rate equation finishes the job for that piece of the system.

The balance tells you a lot before any formula does. Pave a meadow into a parking lot, and the ditch below it starts overflowing in storms it used to handle. Draw the boundary around the site: the rain that falls on it either soaks into the ground or runs off. The meadow's soil took in a large share of each storm, and pavement takes in very little. The rain hasn't changed, so the runoff has to grow. The Rational Method Lesson puts a number on how much.

A balance of water, or of what it carries. Most of the topic balances water. Rain on a watershed, flow down a channel, the split at a pipe junction, a well drawing on an aquifer: in each, water is moved but never made or used up, so nothing reacts. The stored term matters whenever water is held for a while, in the soil or behind a dam. The rest of the topic balances what the water carries: BOD, dissolved oxygen, chloride, solids. Concentration is mass per volume, so you can't add concentrations, only masses. Flow times concentration is mass per unit of time, and that's what adds where two streams meet.

The chain from rain to river. The topic follows the water, roughly in the order it travels. Rain falls and runs off the land. Channels and pipes carry water by gravity, and pumps and mains push it under pressure. A treatment plant cleans it, and an outfall discharges it back into a river. Some of the rain soaks in instead and becomes groundwater, which wells pump back up. Each link has its own tools, chiefly a rate equation that finishes its balance. Intensity-duration-frequency (IDF) data and return periods choose the storm, Q=CIAQ = CIA or a curve number gives the runoff, Manning's equation runs channels and sewers, Hazen-Williams and pump power run the mains, Darcy's law runs groundwater, loading rates size treatment, and below the outfall the river mixes, then decays.

Balance the water Balance the mass it carries soaks in pumped from wells Rain Runoff Channels and pipes Pumps and mains Treatment Discharge Groundwater IDF curves, return periods Q = CIA, curve numbers Manning's equation Hazen-Williams, pump power loading rates V/Q, Q/A mixing, first-order decay Darcy's law, wells
The topic's chain, from rain to river
The links that move water balance the water, and the links that clean and discharge it balance the mass it carries. Under each link are the main tools its Lessons use.

The Lessons below are grouped by link: four on rain and runoff, four on channels and sewers, four on water mains and pumps, two on groundwater and wells, three on what the water carries into a river, and three on treatment.

Reactions that take the same fraction every day. The reacted term switches on when the water carries something that gets used up. In this topic, that's mostly organic waste, measured as BOD, being eaten by bacteria, and it follows first-order decay: the rate of loss is proportional to what's left. Bacteria with half as much food eat half as fast, so the same fraction of what remains disappears each day, and the amount left falls along an exponential curve that never quite reaches zero.

Units sized by loading rates. A treatment unit is judged by how its flow compares with its size, and each comparison is a single division. The volume over the flow, V/QV/Q, is how long the water stays. The flow over the surface area, Q/AQ/A, is how fast the water rises toward the outlet, and a particle has to sink faster than that to stay in the tank. Weir loading and filtration rate are the same kind of division, by a weir's length or a filter's area.

Try sorting a few situations. Each calls for one or two of these ideas.

Checkpoint
1 of 3

A new subdivision drains to a pond that holds back storm runoff and lets it out slowly through a small pipe. Which idea describes what the pond does to the flow leaving the site?

A.
A loading rate: the pond's surface area sets how fast the runoff can pass through to the pipe
B.
A balance of water with storage: the pond holds the excess and releases it later, at a lower peak
C.
First-order decay: the pond uses up a fixed fraction of the runoff for each hour it sits there
D.
A balance of water that loses volume: the pond keeps part of the runoff, so less water leaves the site

When a question in this topic looks unfamiliar, find its link on the chain, write the balance first, and then look for the one rate equation that finishes it.

Lessons

  1. 1The Rational MethodPeak runoff is how hard it rains, times the share that runs off, times the area.
  2. 2Time of Concentration and Design StormsThe design storm lasts just long enough for the whole watershed to contribute.
  3. 3Curve Number RunoffThe ground soaks up rain until it can't, and the curve number says how soon.
  4. 4Hydrographs and DetentionDetention can't make runoff disappear; it can only make it wait.
  5. 5Manning's EquationGravity pulls water down the channel, and friction from the wetted boundary holds it back.
  6. 6Designing ChannelsRun Manning's equation backward, and it designs the channel.
  7. 7Specific Energy and Critical FlowThe same flow can run shallow and fast or deep and slow, and critical depth divides the two.
  8. 8Flow in SewersA sewer carries the most a little below full.
  9. 9Hazen-Williams Head LossWater utilities use a friction formula built for water in real pipes.
  10. 10Pressures in Water MainsThe pressure at the tap is what's left of the reservoir's height after friction takes its share.
  11. 11Pump Head and PowerA pump buys head with power, and efficiency sets the price.
  12. 12Pump Curves and Operating PointsA pump runs wherever its curve crosses the system's, so changing either one moves it.
  13. 13Groundwater and Darcy's LawGroundwater creeps through pores, and only the pores carry it.
  14. 14Steady Flow to WellsA pumped well pulls the water table into a cone, and the cone's shape gives the flow.
  15. 15Mixing and Mass LoadingMass adds at a confluence; concentrations don't.
  16. 16Oxygen DemandBacteria eating waste breathe the river's oxygen, and BOD measures their appetite.
  17. 17BOD KineticsBOD is exerted fast at first and then ever more slowly, like a cooling cup of coffee.
  18. 18Sizing Treatment UnitsTreatment units are sized by how fast water passes through them, not by how big they look.
  19. 19Settling and Particle RemovalA particle is captured if it reaches the floor before the water reaches the weir.
  20. 20Activated SludgeAn aeration basin is a farm for bacteria, and the operator runs it by deciding how many to keep.